2010
Table Of Contents
- Contents
- Part 1 Tubes and Pipes
- 1 Get Started with Tube & Pipe
- 2 Route Basics
- 3 Set Styles
- 4 Create Rigid Routes and Runs
- Workflow for Rigid Routes
- Create Auto Route Regions
- Manually Create Parametric Regions
- Automatically Dimension Route Sketches
- Create Segments With Precise Values
- Define Parallel and Perpendicular Segments
- Snap Route Points to Existing Geometry
- Place Constraints On Route Sketches
- Create Bends Between Existing Pipe Segments
- Create Pipe Routes With Custom Bends
- Create Bent Tube Routes
- Realign 3D Orthogonal Route Tool
- Control Dimension Visibility
- Populated Routes
- 5 Create and Edit Flexible Hose Routes
- 6 Edit Rigid Routes and Runs
- 7 Use Content Center Libraries
- 8 Author and Publish
- 9 Document Routes and Runs
- Part 2 Cable and Harness
- 10 Get Started with Cable and Harness
- 11 Work With Harness Assemblies
- 12 Use the Cable and Harness Library
- 13 Work with Wires and Cables
- 14 Work with Segments
- 15 Route Wires and Cables
- 16 Work with Splices
- 17 Work with Ribbon Cables
- 18 Generate Reports
- 19 Work With Nailboards and Drawings
- Part 3 IDF Translator
- Index
NOTE Label and font size can be adjusted on the label definition in the Cable
and Harness Library.
4 For the purpose of this exercise, change the default label display setting
back to hide. (Right click the harness assembly, select Nailboard Settings,
click the Display tab, and clear the Show Labels check box.)
Change Nailboard Displays
Once the nailboard is created and the harness is placed, you can change the
display for segments, wires, cable wires, wire stubs, and cable wire stubs using
the context menu, and tools on the Cable and Harness tab. You can also
change the display for connector base views.
Change Segment and Wire Line Display
By default, nailboard wires and cable wires are set to display as thin lines.
Segments are set to display as actual diameter. You can switch the display for
an individual object in the nailboard drawing or all harness objects of one
type.
To change the segment, wire, or cable wire display once the nailboard is
created, right-click and use the display options on the context menu.
Change segment display
1 In the active nailboard drawing sketch, select the segment to change.
2 Right-click and clear the Display as Actual Diameter check box.
Change Nailboard Displays | 351