2010
Table Of Contents
- Contents
- Part 1 Tubes and Pipes
- 1 Get Started with Tube & Pipe
- 2 Route Basics
- 3 Set Styles
- 4 Create Rigid Routes and Runs
- Workflow for Rigid Routes
- Create Auto Route Regions
- Manually Create Parametric Regions
- Automatically Dimension Route Sketches
- Create Segments With Precise Values
- Define Parallel and Perpendicular Segments
- Snap Route Points to Existing Geometry
- Place Constraints On Route Sketches
- Create Bends Between Existing Pipe Segments
- Create Pipe Routes With Custom Bends
- Create Bent Tube Routes
- Realign 3D Orthogonal Route Tool
- Control Dimension Visibility
- Populated Routes
- 5 Create and Edit Flexible Hose Routes
- 6 Edit Rigid Routes and Runs
- 7 Use Content Center Libraries
- 8 Author and Publish
- 9 Document Routes and Runs
- Part 2 Cable and Harness
- 10 Get Started with Cable and Harness
- 11 Work With Harness Assemblies
- 12 Use the Cable and Harness Library
- 13 Work with Wires and Cables
- 14 Work with Segments
- 15 Route Wires and Cables
- 16 Work with Splices
- 17 Work with Ribbon Cables
- 18 Generate Reports
- 19 Work With Nailboards and Drawings
- Part 3 IDF Translator
- Index
Move the harness assembly in the drawing view.
1 Click the harness segment, and then drag the cursor to the location shown
in the illustration.
2 Release the mouse to complete the move.
The harness is moved and redrawn in the selected location.
3 Undo to return the harness to its original position in the center of the
drawing.
Arrange the Harness Segments
To arrange segments use Pivot to fix segment points, and then click and drag
the ends of the segments around that pivot point.
In this exercise, you arrange the harness segments in vertical and horizontal
directions using grid snap for precision placement.
Arrange the harness segments
1
On the ribbon, click Nailboard tab ➤ Edit panel ➤ Edit.
2
In the active nailboard drawing sketch, click Nailboard tab
➤ Edit panel ➤ Pivot.
Arrange the Harness Segments | 347