2010
Table Of Contents
- Contents
- Part 1 Tubes and Pipes
- 1 Get Started with Tube & Pipe
- 2 Route Basics
- 3 Set Styles
- 4 Create Rigid Routes and Runs
- Workflow for Rigid Routes
- Create Auto Route Regions
- Manually Create Parametric Regions
- Automatically Dimension Route Sketches
- Create Segments With Precise Values
- Define Parallel and Perpendicular Segments
- Snap Route Points to Existing Geometry
- Place Constraints On Route Sketches
- Create Bends Between Existing Pipe Segments
- Create Pipe Routes With Custom Bends
- Create Bent Tube Routes
- Realign 3D Orthogonal Route Tool
- Control Dimension Visibility
- Populated Routes
- 5 Create and Edit Flexible Hose Routes
- 6 Edit Rigid Routes and Runs
- 7 Use Content Center Libraries
- 8 Author and Publish
- 9 Document Routes and Runs
- Part 2 Cable and Harness
- 10 Get Started with Cable and Harness
- 11 Work With Harness Assemblies
- 12 Use the Cable and Harness Library
- 13 Work with Wires and Cables
- 14 Work with Segments
- 15 Route Wires and Cables
- 16 Work with Splices
- 17 Work with Ribbon Cables
- 18 Generate Reports
- 19 Work With Nailboards and Drawings
- Part 3 IDF Translator
- Index
Set Display Behavior
Before you create a nailboard, you can verify or change the defaults that
control:
■ Lines for segments and wires, including cable wires
■ Fan state (fan in or fan out)
■ Display behavior for fanned in wire stubs and cable wire stubs
■ Sorting direction and angle for fanned out wire stubs and cable wire stubs
■ Color style for looms assigned to segments and wires/cable wires.
■ Offset, orientation, display style, and scale for connector base views.
■
NOTE Once the nailboard is created, you can control the display state for
looms and labels. Right-click the harness assembly in the Cable & Harness
browser and select Nailboard Settings, Display tab.
Defaults for new nailboards are set using either the Harness Settings or
Nailboard View dialog boxes, depending on how you create the nailboard.
In this exercise, you view the default display settings for the active assembly
and create a nailboard drawing.
Create a nailboard for the first harness assembly
1 Double-click Harness Assembly1 as the assembly to document.
2 To view the default settings, right-click Harness Assembly1 in the browser,
select Harness Settings from the context menu, and then click the
Nailboard tab.
3 Review the loom color style settings on the Wires/Cables and Segments
tabs, and then click OK or Cancel.
4
On the ribbon, click Cable and Harness tab ➤ Manage panel
➤ Nailboard.
5 On the Open Template dialog box, select the default template,
Standard.idw, and then click OK.
Set Display Behavior | 345