2010
Table Of Contents
- Contents
- Part 1 Tubes and Pipes
- 1 Get Started with Tube & Pipe
- 2 Route Basics
- 3 Set Styles
- 4 Create Rigid Routes and Runs
- Workflow for Rigid Routes
- Create Auto Route Regions
- Manually Create Parametric Regions
- Automatically Dimension Route Sketches
- Create Segments With Precise Values
- Define Parallel and Perpendicular Segments
- Snap Route Points to Existing Geometry
- Place Constraints On Route Sketches
- Create Bends Between Existing Pipe Segments
- Create Pipe Routes With Custom Bends
- Create Bent Tube Routes
- Realign 3D Orthogonal Route Tool
- Control Dimension Visibility
- Populated Routes
- 5 Create and Edit Flexible Hose Routes
- 6 Edit Rigid Routes and Runs
- 7 Use Content Center Libraries
- 8 Author and Publish
- 9 Document Routes and Runs
- Part 2 Cable and Harness
- 10 Get Started with Cable and Harness
- 11 Work With Harness Assemblies
- 12 Use the Cable and Harness Library
- 13 Work with Wires and Cables
- 14 Work with Segments
- 15 Route Wires and Cables
- 16 Work with Splices
- 17 Work with Ribbon Cables
- 18 Generate Reports
- 19 Work With Nailboards and Drawings
- Part 3 IDF Translator
- Index
Unroute
Using a combination of tools on the Unroute Wires dialog box, there are
several options for unrouting wires and cables. You can unroute:
■ Selected wires or cables from all segments (default)
■ Selected wires or cables from selected segments
■ All wires or cables from all segments
When wires or cables are unrouted from the specified segments, the wires
behave as if the segment was deleted, and return to their point-to-point
connection position.
All work points on wires or cable wires are deleted when the wires are unrouted
from all segments. The work points remain when a wire or cable wire is
unrouted from selected segments only.
When the last object is unrouted from a segment that is set to calculate size
from wires (including cable wires), the segment diameter does not change
from the diameter it had with that last object in it. The current segment is
not resized when all wires and cables are unrouted at once.
Rather than unroute an object entirely, it is often necessary to unroute it from
one or more individual segments. In the following exercises you unroute a
selected wire, and then unroute all remaining wires. You also unroute a cable.
Unroute Wires
Individual, or discrete, wires are unrouted independent of one another.
Unroute selected wires from selected segments
1 With Harness Assembly1 active, click Cable and Harness tab ➤ Route
panel ➤ Unroute
.
2 Verify the All Wires check box is not selected. In the graphics window,
select Wire1 (1) as the wire to unroute.
Unroute | 301