2010
Table Of Contents
- Contents
- Part 1 Tubes and Pipes
- 1 Get Started with Tube & Pipe
- 2 Route Basics
- 3 Set Styles
- 4 Create Rigid Routes and Runs
- Workflow for Rigid Routes
- Create Auto Route Regions
- Manually Create Parametric Regions
- Automatically Dimension Route Sketches
- Create Segments With Precise Values
- Define Parallel and Perpendicular Segments
- Snap Route Points to Existing Geometry
- Place Constraints On Route Sketches
- Create Bends Between Existing Pipe Segments
- Create Pipe Routes With Custom Bends
- Create Bent Tube Routes
- Realign 3D Orthogonal Route Tool
- Control Dimension Visibility
- Populated Routes
- 5 Create and Edit Flexible Hose Routes
- 6 Edit Rigid Routes and Runs
- 7 Use Content Center Libraries
- 8 Author and Publish
- 9 Document Routes and Runs
- Part 2 Cable and Harness
- 10 Get Started with Cable and Harness
- 11 Work With Harness Assemblies
- 12 Use the Cable and Harness Library
- 13 Work with Wires and Cables
- 14 Work with Segments
- 15 Route Wires and Cables
- 16 Work with Splices
- 17 Work with Ribbon Cables
- 18 Generate Reports
- 19 Work With Nailboards and Drawings
- Part 3 IDF Translator
- Index
11 Accept all other settings under Properties and Physical.
12 Under Default Contents, click the arrow to select Wire ID from the
Property list, and then click Insert Property.
13 Click Save and do not close the dialog box.
Modify Library Wire and Cable Definitions
Using the object types, the listed categories, the lists of individual objects, and
the tools in the library, you can select harness objects to copy, modify, or
remove.
Copy Library Definitions
In this exercise, you copy a wire that you created.
Copy a library wire definition
1 With the Cable & Harness Library dialog box still open, go to the list of
wires, and then select the BLU_EE_22 wire that you created.
2 Click the Copy tool.
A copy of the wire BLU_EE_22 is added to the wire list under the original
wire. The default name of the copied wire is BLU_EE_22 Copy. You can
make up to 9 copies of the same wire before renaming it.
Edit Library Definitions
You can edit any definition in the library except the Default Library definitions
such as the Default Library Wire or Default Library Loom. For all harness object
types, you can edit the general and custom properties. For cables, you can also
add and remove wires from the cable.
Edit a wire definition in the library
1
On the Cable & Harness Library dialog box, select the wire
BLU_EE_22_Copy in the list, and then click the Edit tool.
242 | Chapter 12 Use the Cable and Harness Library