2010
Table Of Contents
- Contents
- Part 1 Tubes and Pipes
- 1 Get Started with Tube & Pipe
- 2 Route Basics
- 3 Set Styles
- 4 Create Rigid Routes and Runs
- Workflow for Rigid Routes
- Create Auto Route Regions
- Manually Create Parametric Regions
- Automatically Dimension Route Sketches
- Create Segments With Precise Values
- Define Parallel and Perpendicular Segments
- Snap Route Points to Existing Geometry
- Place Constraints On Route Sketches
- Create Bends Between Existing Pipe Segments
- Create Pipe Routes With Custom Bends
- Create Bent Tube Routes
- Realign 3D Orthogonal Route Tool
- Control Dimension Visibility
- Populated Routes
- 5 Create and Edit Flexible Hose Routes
- 6 Edit Rigid Routes and Runs
- 7 Use Content Center Libraries
- 8 Author and Publish
- 9 Document Routes and Runs
- Part 2 Cable and Harness
- 10 Get Started with Cable and Harness
- 11 Work With Harness Assemblies
- 12 Use the Cable and Harness Library
- 13 Work with Wires and Cables
- 14 Work with Segments
- 15 Route Wires and Cables
- 16 Work with Splices
- 17 Work with Ribbon Cables
- 18 Generate Reports
- 19 Work With Nailboards and Drawings
- Part 3 IDF Translator
- Index
You also need to click OK on the dialog box again after the message box
closes.
4 Click
➤ Save and click OK in the dialog box.
5 Right-click and select Finish Edit.
In a later exercise, you set the RefDes value for the occurrences.
Practice Your Skills
Use the skills you just learned to add pins and a RefDes placeholder to the
other electrical parts.
1 Edit the part 360575:1, and add pins at each hole. Name the pins to
match their number label.
2 Add the reference designator U?.
3 Right-click and select Finish Edit. Alternatively, click Return on the
Ribbon.
4 In the browser, expand the PCB subassembly to locate and edit part LTP.
5 Add the pins as shown. Pin 1 is the pin closest to part 360124.
220 | Chapter 10 Get Started with Cable and Harness