2010
Table Of Contents
- Contents
- Part 1 Tubes and Pipes
- 1 Get Started with Tube & Pipe
- 2 Route Basics
- 3 Set Styles
- 4 Create Rigid Routes and Runs
- Workflow for Rigid Routes
- Create Auto Route Regions
- Manually Create Parametric Regions
- Automatically Dimension Route Sketches
- Create Segments With Precise Values
- Define Parallel and Perpendicular Segments
- Snap Route Points to Existing Geometry
- Place Constraints On Route Sketches
- Create Bends Between Existing Pipe Segments
- Create Pipe Routes With Custom Bends
- Create Bent Tube Routes
- Realign 3D Orthogonal Route Tool
- Control Dimension Visibility
- Populated Routes
- 5 Create and Edit Flexible Hose Routes
- 6 Edit Rigid Routes and Runs
- 7 Use Content Center Libraries
- 8 Author and Publish
- 9 Document Routes and Runs
- Part 2 Cable and Harness
- 10 Get Started with Cable and Harness
- 11 Work With Harness Assemblies
- 12 Use the Cable and Harness Library
- 13 Work with Wires and Cables
- 14 Work with Segments
- 15 Route Wires and Cables
- 16 Work with Splices
- 17 Work with Ribbon Cables
- 18 Generate Reports
- 19 Work With Nailboards and Drawings
- Part 3 IDF Translator
- Index
Nominal Diameter: 1/4 inch
Schedule: 80
Keep in mind:
■ SampleStandard is the Standard parameter (not Standard Organization)
you manually set for the part family standard properties during
publishing.
■ When SampleStandard is selected in the Standard list, enable the
materials filter to display all available materials in the list. If the desired
material is not displayed, use the Content Center tool to verify the
part family does own this material. Use the Styles Editor tool to ensure
this material is added to the Styles Library.
9 Accept the other general settings.
10 On the Tube & Pipe Styles dialog box, Rules tab, specify:
Min: 1.000 inch
Max: 200.000 inch
Inc.: 0.1 inch
11 Repeat steps 4 through 9 to select the 90-degree elbow part.
TIP Notice that the couplings are not required for welded routes, so they
are listed as optional. Pause the cursor over the symbol to view the tooltip.
12 Click Save.
13 Click Close.
The new style Custom Welded Pipe (1/4, 90) is created and available for
creating new rigid pipe routes.
182 | Chapter 8 Author and Publish