2010
Table Of Contents
- Contents
- Part 1 Tubes and Pipes
- 1 Get Started with Tube & Pipe
- 2 Route Basics
- 3 Set Styles
- 4 Create Rigid Routes and Runs
- Workflow for Rigid Routes
- Create Auto Route Regions
- Manually Create Parametric Regions
- Automatically Dimension Route Sketches
- Create Segments With Precise Values
- Define Parallel and Perpendicular Segments
- Snap Route Points to Existing Geometry
- Place Constraints On Route Sketches
- Create Bends Between Existing Pipe Segments
- Create Pipe Routes With Custom Bends
- Create Bent Tube Routes
- Realign 3D Orthogonal Route Tool
- Control Dimension Visibility
- Populated Routes
- 5 Create and Edit Flexible Hose Routes
- 6 Edit Rigid Routes and Runs
- 7 Use Content Center Libraries
- 8 Author and Publish
- 9 Document Routes and Runs
- Part 2 Cable and Harness
- 10 Get Started with Cable and Harness
- 11 Work With Harness Assemblies
- 12 Use the Cable and Harness Library
- 13 Work with Wires and Cables
- 14 Work with Segments
- 15 Route Wires and Cables
- 16 Work with Splices
- 17 Work with Ribbon Cables
- 18 Generate Reports
- 19 Work With Nailboards and Drawings
- Part 3 IDF Translator
- Index
7 Click connection number button 2, and then repeat Step 6 using the
following image to set the Connection Point and Connection Axis.
8 Specify the following ISOGEN properties:
Type: ELBOW
SKey: ELBW - Elbow - Butt Weld (90 degree and 45 degree)
ITEM-CODE: 90 45 LLR
Description: ELBOW 90 45 DEGREE BW ASTM A043 WPF316 SCH.40
9 Click OK.
10 On the Authoring Result dialog box, click OK.
11 Save the authored 45-degree elbow iPart, and close the part file.
Author the 90-degree elbow iPart
1 Open the 90LongElbow.ipt part file.
2 Repeat the previous steps using the same settings and connection points
as for the 45-degree elbow iPart.
3 Save the authored 90-degree elbow iPart, and close the part file.
172 | Chapter 8 Author and Publish