2010
Table Of Contents
- Contents
- Part 1 Tubes and Pipes
- 1 Get Started with Tube & Pipe
- 2 Route Basics
- 3 Set Styles
- 4 Create Rigid Routes and Runs
- Workflow for Rigid Routes
- Create Auto Route Regions
- Manually Create Parametric Regions
- Automatically Dimension Route Sketches
- Create Segments With Precise Values
- Define Parallel and Perpendicular Segments
- Snap Route Points to Existing Geometry
- Place Constraints On Route Sketches
- Create Bends Between Existing Pipe Segments
- Create Pipe Routes With Custom Bends
- Create Bent Tube Routes
- Realign 3D Orthogonal Route Tool
- Control Dimension Visibility
- Populated Routes
- 5 Create and Edit Flexible Hose Routes
- 6 Edit Rigid Routes and Runs
- 7 Use Content Center Libraries
- 8 Author and Publish
- 9 Document Routes and Runs
- Part 2 Cable and Harness
- 10 Get Started with Cable and Harness
- 11 Work With Harness Assemblies
- 12 Use the Cable and Harness Library
- 13 Work with Wires and Cables
- 14 Work with Segments
- 15 Route Wires and Cables
- 16 Work with Splices
- 17 Work with Ribbon Cables
- 18 Generate Reports
- 19 Work With Nailboards and Drawings
- Part 3 IDF Translator
- Index
Edit category properties and part families
1
On the ribbon, click Manage tab ➤ Content Center panel
➤ Editor.
2 Use appropriate tools to make edits.
Place Tube and Pipe Parts
Both conduit parts and fittings can be placed into a tube and pipe assembly
from the Content Center using AutoDrop.
The following tools are available to locate tube and pipe library parts:
■ Use the Place from Content Center tool to directly place library parts. For
detailed instructions, see
Insert Library Parts Using AutoDrop on page 132
in Chapter 6.
■ To replace an existing fitting or all instances in the same fitting type,
right-click the fitting to replace and start the Replace from Content Center
tool. For detailed instructions, see
Replace Existing Fittings on page 136 in
Chapter 6.
154 | Chapter 7 Use Content Center Libraries