2010
Table Of Contents
- Contents
- Part 1 Tubes and Pipes
- 1 Get Started with Tube & Pipe
- 2 Route Basics
- 3 Set Styles
- 4 Create Rigid Routes and Runs
- Workflow for Rigid Routes
- Create Auto Route Regions
- Manually Create Parametric Regions
- Automatically Dimension Route Sketches
- Create Segments With Precise Values
- Define Parallel and Perpendicular Segments
- Snap Route Points to Existing Geometry
- Place Constraints On Route Sketches
- Create Bends Between Existing Pipe Segments
- Create Pipe Routes With Custom Bends
- Create Bent Tube Routes
- Realign 3D Orthogonal Route Tool
- Control Dimension Visibility
- Populated Routes
- 5 Create and Edit Flexible Hose Routes
- 6 Edit Rigid Routes and Runs
- 7 Use Content Center Libraries
- 8 Author and Publish
- 9 Document Routes and Runs
- Part 2 Cable and Harness
- 10 Get Started with Cable and Harness
- 11 Work With Harness Assemblies
- 12 Use the Cable and Harness Library
- 13 Work with Wires and Cables
- 14 Work with Segments
- 15 Route Wires and Cables
- 16 Work with Splices
- 17 Work with Ribbon Cables
- 18 Generate Reports
- 19 Work With Nailboards and Drawings
- Part 3 IDF Translator
- Index
Use Content Center
Libraries
The Autodesk Inventor
®
Content Center provides standard Autodesk Inventor parts, as well
as conduit parts and tube and pipe fittings. The components comply with industry standards.
In this chapter, you learn the basics about the Content Center.
About Content Center
The Content Center is an Autodesk Inventor tool used for accessing and
maintaining the libraries. You can create as many libraries as you need on the
Autodesk
®
Vault server, and attach them to the Content Center using the
Configure Content Center Libraries tool.
Autodesk Inventor
®
Routed Systems provides three tools to manage libraries,
configure libraries, and edit library content with varied functions:
To use libraries in the Content Center, the server must
be installed. You can create new libraries on the server
Autodesk Vault server
and then use the Configure Content Center Libraries
tool to attach it to the Content Center. You can perman-
ently delete a library from the server after you detach it
from the Content Center.
You can attach the libraries on the server to the Content
Center.
Configure Content
Center Libraries tool
You can edit library parts from within the Content
Center.
Content Center Editor
tool
7
149