2010
Table Of Contents
- Contents
- Part 1 Tubes and Pipes
- 1 Get Started with Tube & Pipe
- 2 Route Basics
- 3 Set Styles
- 4 Create Rigid Routes and Runs
- Workflow for Rigid Routes
- Create Auto Route Regions
- Manually Create Parametric Regions
- Automatically Dimension Route Sketches
- Create Segments With Precise Values
- Define Parallel and Perpendicular Segments
- Snap Route Points to Existing Geometry
- Place Constraints On Route Sketches
- Create Bends Between Existing Pipe Segments
- Create Pipe Routes With Custom Bends
- Create Bent Tube Routes
- Realign 3D Orthogonal Route Tool
- Control Dimension Visibility
- Populated Routes
- 5 Create and Edit Flexible Hose Routes
- 6 Edit Rigid Routes and Runs
- 7 Use Content Center Libraries
- 8 Author and Publish
- 9 Document Routes and Runs
- Part 2 Cable and Harness
- 10 Get Started with Cable and Harness
- 11 Work With Harness Assemblies
- 12 Use the Cable and Harness Library
- 13 Work with Wires and Cables
- 14 Work with Segments
- 15 Route Wires and Cables
- 16 Work with Splices
- 17 Work with Ribbon Cables
- 18 Generate Reports
- 19 Work With Nailboards and Drawings
- Part 3 IDF Translator
- Index
Check the bend radius
1 Activate the hose route.
2 Right-click the hose route in the browser, and select Bend Radius ➤
Check.
3 If the Error dialog box displays the violations against the minimum bend
radius, click OK.
Optionally, right-click the hose route or the pipe run in the browser, and
select Bend Radius ➤ Clear Violation.
4 Edit the hose route.
5 Repeat Steps 2 through 4 until no violations occur.
Delete Flexible Hose Routes
You can delete both populated and unpopulated hose routes. When deleting,
you are prompted to indicate whether to delete all segments and fittings in
the route or only the segments. If only segments are deleted, the fittings are
moved to the top of the browser and are available for future use. For this
exercise, it is recommended that you delete both the hose segments and the
fittings.
Delete a hose route
1 Activate the AirSystem2:1 run.
2 If the Flexible Hose 01 subassembly is collapsed, click to expand it.
3 Right-click Hose1 and select Delete Route.
4 In the Delete Route Components dialog box, make sure Fittings and
Segments of Selected Route is selected, and then click OK.
The Flexible Hose subassembly is deleted completely.
5 Save the top-level assembly. This run becomes empty.
Delete Flexible Hose Routes | 107