2009
Table Of Contents
- Contents
- Tubes and Pipes
- 1 Getting Started with Tube & Pipe
- 2 Route Basics
- 3 Setting Styles
- 4 Creating Rigid Routes and Runs
- General Workflow for Rigid Routes
- Creating Auto Route Regions
- Manually Creating Parametric Regions
- Automatically Dimension Route Sketches
- Create Segments With Precise Values
- Define Parallel and Perpendicular Segments
- Snap Route Points to Existing Geometry
- Place Constraints On Route Sketches
- Create Bends Between Existing Pipe Segments
- Create Pipe Routes With Custom Bends
- Create Bent Tube Routes
- Realign 3D Orthogonal Route Tool
- Control Dimension Visibility
- Populated Routes
- 5 Creating and Editing Flexible Hose Routes
- 6 Editing Rigid Routes and Runs
- 7 Using Content Center Libraries
- 8 Authoring and Publishing
- 9 Documenting Routes and Runs
- Cable and Harness
- 10 Getting Started with Cable and Harness
- 11 Working With Harness Assemblies
- 12 Using the Cable and Harness Library
- 13 Working with Wires and Cables
- About Wires and Cables
- Setting Modeling and Curvature Behavior
- Inserting Wires and Cables Manually
- Moving Wires and Cables
- Deleting Wires and Cables
- Replacing Wires
- Assigning Virtual Parts
- Importing Harness Data
- Adding Shape to Wires and Cable Wires
- Setting Occurrence Properties
- Changing Wire and Cable Displays
- 14 Working with Segments
- 15 Routing Wires and Cables
- 16 Working with Splices
- 17 Working with Ribbon Cables
- 18 Generating Reports
- 19 Working Nailboards and Drawings
- IDF Translator
- Index
4 Dimension the other two segments as shown, right-click and select Done.
Add Properties
Use the Property Display tool to view and display harness properties for wires,
cable wires, pins, splices, and segments displayed on the drawing. You can
select individual or multiple objects for display.
To place the properties in the drawing, you select the location for the first
item in the selection set. The system automatically places all other properties
offset from the associated harness object based on this initial selection.
Once placed you can delete them, or move and adjust the displayed properties
to their desired position by right-clicking and rotating 90 degrees in the
clockwise or counterclockwise directions. You can also edit the text to change
the font. If the harness object to which a property is associated is moved, the
property is also moved.
Add properties to pins, parts, and a selected wire
1 In the graphics window, zoom in on the harness.
2 On the Nailboard panel bar, click the Property Display tool.
3 On the Property Display dialog box under Select Filters, click All Pins.
4 In the Property Name list, select Pin Name.
Add Properties | 355