2009
Table Of Contents
- Contents
- Tubes and Pipes
- 1 Getting Started with Tube & Pipe
- 2 Route Basics
- 3 Setting Styles
- 4 Creating Rigid Routes and Runs
- General Workflow for Rigid Routes
- Creating Auto Route Regions
- Manually Creating Parametric Regions
- Automatically Dimension Route Sketches
- Create Segments With Precise Values
- Define Parallel and Perpendicular Segments
- Snap Route Points to Existing Geometry
- Place Constraints On Route Sketches
- Create Bends Between Existing Pipe Segments
- Create Pipe Routes With Custom Bends
- Create Bent Tube Routes
- Realign 3D Orthogonal Route Tool
- Control Dimension Visibility
- Populated Routes
- 5 Creating and Editing Flexible Hose Routes
- 6 Editing Rigid Routes and Runs
- 7 Using Content Center Libraries
- 8 Authoring and Publishing
- 9 Documenting Routes and Runs
- Cable and Harness
- 10 Getting Started with Cable and Harness
- 11 Working With Harness Assemblies
- 12 Using the Cable and Harness Library
- 13 Working with Wires and Cables
- About Wires and Cables
- Setting Modeling and Curvature Behavior
- Inserting Wires and Cables Manually
- Moving Wires and Cables
- Deleting Wires and Cables
- Replacing Wires
- Assigning Virtual Parts
- Importing Harness Data
- Adding Shape to Wires and Cable Wires
- Setting Occurrence Properties
- Changing Wire and Cable Displays
- 14 Working with Segments
- 15 Routing Wires and Cables
- 16 Working with Splices
- 17 Working with Ribbon Cables
- 18 Generating Reports
- 19 Working Nailboards and Drawings
- IDF Translator
- Index
In this exercise, you create a nailboard view of the harness assembly from an
open drawing and change the fan state and display behavior.
Fan in wires and change display settings
1 Click File ➤ New.
2 In the Open template dialog box, select the default template, Standard.idw,
and then click OK.
3
On the Drawing Views panel bar, click the Nailboard View tool.
4 On the Nailboard View dialog box, ensure that the Nailboard View is
Harness Assembly 2.iam.
5 Click the Display tab and click the Fan In tool.
6 Under Appearance, click the Display as Longest Wire tool.
7 Click OK and close the dialog box.
8 Right-click and select Finish Sketch for a better view of the cable wire
stubs.
9 On the Nailboard panel bar, click the Edit tool.
10 In the browser, right-click Harness Assembly2, and select Nailboard
Settings.
11 On the Nailboard Settings dialog box, click the Display tab, and then
click the Display as Segment tool.
NOTE This technique is the only way to change the fan in the display once
the nailboard drawing is created.
Change Fan State and Display | 353