2009
Table Of Contents
- Contents
- Tubes and Pipes
- 1 Getting Started with Tube & Pipe
- 2 Route Basics
- 3 Setting Styles
- 4 Creating Rigid Routes and Runs
- General Workflow for Rigid Routes
- Creating Auto Route Regions
- Manually Creating Parametric Regions
- Automatically Dimension Route Sketches
- Create Segments With Precise Values
- Define Parallel and Perpendicular Segments
- Snap Route Points to Existing Geometry
- Place Constraints On Route Sketches
- Create Bends Between Existing Pipe Segments
- Create Pipe Routes With Custom Bends
- Create Bent Tube Routes
- Realign 3D Orthogonal Route Tool
- Control Dimension Visibility
- Populated Routes
- 5 Creating and Editing Flexible Hose Routes
- 6 Editing Rigid Routes and Runs
- 7 Using Content Center Libraries
- 8 Authoring and Publishing
- 9 Documenting Routes and Runs
- Cable and Harness
- 10 Getting Started with Cable and Harness
- 11 Working With Harness Assemblies
- 12 Using the Cable and Harness Library
- 13 Working with Wires and Cables
- About Wires and Cables
- Setting Modeling and Curvature Behavior
- Inserting Wires and Cables Manually
- Moving Wires and Cables
- Deleting Wires and Cables
- Replacing Wires
- Assigning Virtual Parts
- Importing Harness Data
- Adding Shape to Wires and Cable Wires
- Setting Occurrence Properties
- Changing Wire and Cable Displays
- 14 Working with Segments
- 15 Routing Wires and Cables
- 16 Working with Splices
- 17 Working with Ribbon Cables
- 18 Generating Reports
- 19 Working Nailboards and Drawings
- IDF Translator
- Index
Unroute Cables
To unroute a cable, you select a single cable wire, and then all cable wires
associated to the same cable are unrouted together.
1 Ensure the Harness Assembly2 is active.
2 Click the Unroute tool, if the Unroute dialog box is not already open.
3 Verify the All Wires and All segments check boxes are cleared.
4 Make sure that the Wires button is selected, and then in the graphics
window, select the black cable wire (1), as the cable wire to unroute.
The cable wire is labeled as Cable1:1 in the browser.
5 Click the Segments button, and then, in the graphics window, click the
segment between the two blue connectors (parts 360575:1 and 360575:2).
6 Click Apply.
Both wires in the cable return to their unrouted state.
Unroute All Wires or Cables from All Segments
In this exercise, you unroute the remaining wires. If the dialog box is not still
open from the previous exercise, select the Unroute tool.
Unroute all wires
1 On the Unroute dialog box, verify that both the All Wires and All
Segments check boxes are selected.
2 Click OK.
The wires are unrouted and wire lengths update to reflect the change.
Unroute Cables | 301