2009
Table Of Contents
- Contents
- Tubes and Pipes
- 1 Getting Started with Tube & Pipe
- 2 Route Basics
- 3 Setting Styles
- 4 Creating Rigid Routes and Runs
- General Workflow for Rigid Routes
- Creating Auto Route Regions
- Manually Creating Parametric Regions
- Automatically Dimension Route Sketches
- Create Segments With Precise Values
- Define Parallel and Perpendicular Segments
- Snap Route Points to Existing Geometry
- Place Constraints On Route Sketches
- Create Bends Between Existing Pipe Segments
- Create Pipe Routes With Custom Bends
- Create Bent Tube Routes
- Realign 3D Orthogonal Route Tool
- Control Dimension Visibility
- Populated Routes
- 5 Creating and Editing Flexible Hose Routes
- 6 Editing Rigid Routes and Runs
- 7 Using Content Center Libraries
- 8 Authoring and Publishing
- 9 Documenting Routes and Runs
- Cable and Harness
- 10 Getting Started with Cable and Harness
- 11 Working With Harness Assemblies
- 12 Using the Cable and Harness Library
- 13 Working with Wires and Cables
- About Wires and Cables
- Setting Modeling and Curvature Behavior
- Inserting Wires and Cables Manually
- Moving Wires and Cables
- Deleting Wires and Cables
- Replacing Wires
- Assigning Virtual Parts
- Importing Harness Data
- Adding Shape to Wires and Cable Wires
- Setting Occurrence Properties
- Changing Wire and Cable Displays
- 14 Working with Segments
- 15 Routing Wires and Cables
- 16 Working with Splices
- 17 Working with Ribbon Cables
- 18 Generating Reports
- 19 Working Nailboards and Drawings
- IDF Translator
- Index
6 In the browser or graphics window, right-click the third work point
created, and then select 3D Move/Rotate.
7 Select or drag a triad segment to move the point to the location shown.
The position of the wire is previewed and any bend radius violations
noted before applying the move.
8 Click OK and the wire recomputes to the new location.
Delete Wire Work Points
You can delete individual wire work points or all points at once.
1 In the browser, right-click the first work point created, and then select
Delete Point on the context menu. The wire recomputes.
2 To remove all points from the wire, right-click Wire 2207, and then select
Delete All Points on the context menu.
The wire returns to its original state and the length of the wire is
recomputed.
Setting Occurrence Properties
Wire and cable occurrences inherit the general properties that were created
at the library level. Occurrence properties can be stored within the assembly
in which the wires and cables are placed. You can override certain library-level
property values with an occurrence property value.
Delete Wire Work Points | 271