2009
Table Of Contents
- Contents
- Tubes and Pipes
- 1 Getting Started with Tube & Pipe
- 2 Route Basics
- 3 Setting Styles
- 4 Creating Rigid Routes and Runs
- General Workflow for Rigid Routes
- Creating Auto Route Regions
- Manually Creating Parametric Regions
- Automatically Dimension Route Sketches
- Create Segments With Precise Values
- Define Parallel and Perpendicular Segments
- Snap Route Points to Existing Geometry
- Place Constraints On Route Sketches
- Create Bends Between Existing Pipe Segments
- Create Pipe Routes With Custom Bends
- Create Bent Tube Routes
- Realign 3D Orthogonal Route Tool
- Control Dimension Visibility
- Populated Routes
- 5 Creating and Editing Flexible Hose Routes
- 6 Editing Rigid Routes and Runs
- 7 Using Content Center Libraries
- 8 Authoring and Publishing
- 9 Documenting Routes and Runs
- Cable and Harness
- 10 Getting Started with Cable and Harness
- 11 Working With Harness Assemblies
- 12 Using the Cable and Harness Library
- 13 Working with Wires and Cables
- About Wires and Cables
- Setting Modeling and Curvature Behavior
- Inserting Wires and Cables Manually
- Moving Wires and Cables
- Deleting Wires and Cables
- Replacing Wires
- Assigning Virtual Parts
- Importing Harness Data
- Adding Shape to Wires and Cable Wires
- Setting Occurrence Properties
- Changing Wire and Cable Displays
- 14 Working with Segments
- 15 Routing Wires and Cables
- 16 Working with Splices
- 17 Working with Ribbon Cables
- 18 Generating Reports
- 19 Working Nailboards and Drawings
- IDF Translator
- Index
As an alternative, you can right-click the wire in the list, and then select
Edit from the context menu.
2 Change the settings as follows and click Save:
Name: BLU_EE_22A
Category: Generic
NOTE Invalid names, such as those that duplicate an existing name, are
indicated in red.
The list of wires automatically expands to show the renamed wire in the
Generic category.
Delete Library Definitions
You can delete a library definition using the Cable and Harness Library dialog
box. If a harness object that is deleted from the library was already added to
a harness assembly, any occurrences of that object in the assembly are not
deleted. You cannot delete wires used by a cable.
NOTE If a wire or cable with the same name as the deleted one is added back
into the Cable and Harness Library before a harness assembly is opened, any
occurrences of the wire automatically update with the new definition the next
time the harness assembly is updated.
In this exercise, you delete the wire definition you added previously.
Delete a wire definition
1 On the Cable and Harness Library dialog box, select the wire to delete:
BLU_EE_22A.
2
Click the Delete tool, and then click Yes to confirm the deletion.
Alternatively, you can right-click the wire, and then select Delete from
the context menu.
3 Look at the list to verify that the wire was deleted.
Delete Library Definitions | 241