2009
Table Of Contents
- Contents
- Tubes and Pipes
- 1 Getting Started with Tube & Pipe
- 2 Route Basics
- 3 Setting Styles
- 4 Creating Rigid Routes and Runs
- General Workflow for Rigid Routes
- Creating Auto Route Regions
- Manually Creating Parametric Regions
- Automatically Dimension Route Sketches
- Create Segments With Precise Values
- Define Parallel and Perpendicular Segments
- Snap Route Points to Existing Geometry
- Place Constraints On Route Sketches
- Create Bends Between Existing Pipe Segments
- Create Pipe Routes With Custom Bends
- Create Bent Tube Routes
- Realign 3D Orthogonal Route Tool
- Control Dimension Visibility
- Populated Routes
- 5 Creating and Editing Flexible Hose Routes
- 6 Editing Rigid Routes and Runs
- 7 Using Content Center Libraries
- 8 Authoring and Publishing
- 9 Documenting Routes and Runs
- Cable and Harness
- 10 Getting Started with Cable and Harness
- 11 Working With Harness Assemblies
- 12 Using the Cable and Harness Library
- 13 Working with Wires and Cables
- About Wires and Cables
- Setting Modeling and Curvature Behavior
- Inserting Wires and Cables Manually
- Moving Wires and Cables
- Deleting Wires and Cables
- Replacing Wires
- Assigning Virtual Parts
- Importing Harness Data
- Adding Shape to Wires and Cable Wires
- Setting Occurrence Properties
- Changing Wire and Cable Displays
- 14 Working with Segments
- 15 Routing Wires and Cables
- 16 Working with Splices
- 17 Working with Ribbon Cables
- 18 Generating Reports
- 19 Working Nailboards and Drawings
- IDF Translator
- Index
Set a reference designator for an electrical part occurrence
1 In the browser, double-click Harness Assembly1, if not already active.
2 Right-click the part name 360124, and then select Harness Properties
from the context menu.
NOTE You can select the parts, but the browser has a gray background.
3 On the Part Properties dialog box, set a RefDes of U3 for the occurrence,
and then click OK.
4 Repeat Steps 2 and 3 to set a RefDes of U7 for part 360575:1.
5 Set a RefDes of U8 for part 360575:2.
6 In the browser, expand the PCB subassembly to locate part LTP, and then
set a RefDes of J12.
The generic placeholder RefDes for each part is overridden at the
occurrence level with the unique value. The RefDes on each part
occurrence is required.
NOTE Once the harness assembly is added, you can also assign terminals,
seals, and plugs to electrical part pins.
Assign Occurrence Reference Designators | 231