2009
Table Of Contents
- Contents
- Tubes and Pipes
- 1 Getting Started with Tube & Pipe
- 2 Route Basics
- 3 Setting Styles
- 4 Creating Rigid Routes and Runs
- General Workflow for Rigid Routes
- Creating Auto Route Regions
- Manually Creating Parametric Regions
- Automatically Dimension Route Sketches
- Create Segments With Precise Values
- Define Parallel and Perpendicular Segments
- Snap Route Points to Existing Geometry
- Place Constraints On Route Sketches
- Create Bends Between Existing Pipe Segments
- Create Pipe Routes With Custom Bends
- Create Bent Tube Routes
- Realign 3D Orthogonal Route Tool
- Control Dimension Visibility
- Populated Routes
- 5 Creating and Editing Flexible Hose Routes
- 6 Editing Rigid Routes and Runs
- 7 Using Content Center Libraries
- 8 Authoring and Publishing
- 9 Documenting Routes and Runs
- Cable and Harness
- 10 Getting Started with Cable and Harness
- 11 Working With Harness Assemblies
- 12 Using the Cable and Harness Library
- 13 Working with Wires and Cables
- About Wires and Cables
- Setting Modeling and Curvature Behavior
- Inserting Wires and Cables Manually
- Moving Wires and Cables
- Deleting Wires and Cables
- Replacing Wires
- Assigning Virtual Parts
- Importing Harness Data
- Adding Shape to Wires and Cable Wires
- Setting Occurrence Properties
- Changing Wire and Cable Displays
- 14 Working with Segments
- 15 Routing Wires and Cables
- 16 Working with Splices
- 17 Working with Ribbon Cables
- 18 Generating Reports
- 19 Working Nailboards and Drawings
- IDF Translator
- Index
Publish the 45-degree elbow iPart
1 Repeat the previous steps to publish the 45-degree elbow iPart to
CustomLibrary.
Use Tube & Pipe ➤ Fittings ➤ Elbows as the category path.
Click Next to go to the next wizard.
2 Accept the default mapping between the iPart family columns and
category parameters and click Next.
3 Accept the default family key columns and click Next.
4 Specify the following family properties and click Next.
Family Naming:
Name: 45Elbow
Description: Butt Weld 45 Elbow
Standard:
Standard Organization: SampleOrganization
Manufacturer: SampleCompany
Standard: SampleStandard
Standard and Revision: 1
5 Review the published elbow information and go back to the preceding
wizards to make appropriate changes as needed. Click Next until you
reach the final screen of the wizard, and then click Finish.
6 Click Publish, and then OK.
Publish the 90-degree elbow iPart
1 Repeat the steps above to publish the 90-degree elbow iPart to
CustomLibrary.
Use Tube & Pipe ➤ Fittings ➤ Elbows as the category path.
Click Next to go to the next wizard.
2 Accept the default mapping between the iPart family columns and
category parameters and click Next.
3 Accept the default family key columns and click Next.
4 Specify the following family properties and click Next.
Family Naming:
Publish Authored Parts | 177