2009
Table Of Contents
- Contents
- Tubes and Pipes
- 1 Getting Started with Tube & Pipe
- 2 Route Basics
- 3 Setting Styles
- 4 Creating Rigid Routes and Runs
- General Workflow for Rigid Routes
- Creating Auto Route Regions
- Manually Creating Parametric Regions
- Automatically Dimension Route Sketches
- Create Segments With Precise Values
- Define Parallel and Perpendicular Segments
- Snap Route Points to Existing Geometry
- Place Constraints On Route Sketches
- Create Bends Between Existing Pipe Segments
- Create Pipe Routes With Custom Bends
- Create Bent Tube Routes
- Realign 3D Orthogonal Route Tool
- Control Dimension Visibility
- Populated Routes
- 5 Creating and Editing Flexible Hose Routes
- 6 Editing Rigid Routes and Runs
- 7 Using Content Center Libraries
- 8 Authoring and Publishing
- 9 Documenting Routes and Runs
- Cable and Harness
- 10 Getting Started with Cable and Harness
- 11 Working With Harness Assemblies
- 12 Using the Cable and Harness Library
- 13 Working with Wires and Cables
- About Wires and Cables
- Setting Modeling and Curvature Behavior
- Inserting Wires and Cables Manually
- Moving Wires and Cables
- Deleting Wires and Cables
- Replacing Wires
- Assigning Virtual Parts
- Importing Harness Data
- Adding Shape to Wires and Cable Wires
- Setting Occurrence Properties
- Changing Wire and Cable Displays
- 14 Working with Segments
- 15 Routing Wires and Cables
- 16 Working with Splices
- 17 Working with Ribbon Cables
- 18 Generating Reports
- 19 Working Nailboards and Drawings
- IDF Translator
- Index
8 Click Next.
The preview image of the published part is displayed. You can change
the thumbnail image for future use in the Content Center.
9 Click Finish.
10 On the Publish Guide dialog box, click Publish.
11 When the Publish Result dialog box prompts about the successful publish,
click OK.
When processing is complete, the part is added to Custom Library ➤
Tube & Pipe ➤ Conduits ➤ Pipes category. You can use the Content
Center Editor tool to verify the published pipe part family.
Once published, the Standard information is available in the lists on the Tube
& Pipe Styles dialog box. The part materials are available when the appropriate
standard specification is selected.
You can also navigate to the published union part family using the Content
Center tool and practice using the AutoDrop functionality to place it in a
sample model or model of your choice.
Elbow iPart
Use the skills you just learned to publish the 45-degree and 90-degree elbow
iParts to Custom Library ➤ Tube & Pipe ➤ Fittings ➤ Elbows category.
176 | Chapter 8 Authoring and Publishing