2009
Table Of Contents
- Contents
- Tubes and Pipes
- 1 Getting Started with Tube & Pipe
- 2 Route Basics
- 3 Setting Styles
- 4 Creating Rigid Routes and Runs
- General Workflow for Rigid Routes
- Creating Auto Route Regions
- Manually Creating Parametric Regions
- Automatically Dimension Route Sketches
- Create Segments With Precise Values
- Define Parallel and Perpendicular Segments
- Snap Route Points to Existing Geometry
- Place Constraints On Route Sketches
- Create Bends Between Existing Pipe Segments
- Create Pipe Routes With Custom Bends
- Create Bent Tube Routes
- Realign 3D Orthogonal Route Tool
- Control Dimension Visibility
- Populated Routes
- 5 Creating and Editing Flexible Hose Routes
- 6 Editing Rigid Routes and Runs
- 7 Using Content Center Libraries
- 8 Authoring and Publishing
- 9 Documenting Routes and Runs
- Cable and Harness
- 10 Getting Started with Cable and Harness
- 11 Working With Harness Assemblies
- 12 Using the Cable and Harness Library
- 13 Working with Wires and Cables
- About Wires and Cables
- Setting Modeling and Curvature Behavior
- Inserting Wires and Cables Manually
- Moving Wires and Cables
- Deleting Wires and Cables
- Replacing Wires
- Assigning Virtual Parts
- Importing Harness Data
- Adding Shape to Wires and Cable Wires
- Setting Occurrence Properties
- Changing Wire and Cable Displays
- 14 Working with Segments
- 15 Routing Wires and Cables
- 16 Working with Splices
- 17 Working with Ribbon Cables
- 18 Generating Reports
- 19 Working Nailboards and Drawings
- IDF Translator
- Index
Restore a default fitting
1 Activate the AirSystem1:1 run.
2 Right-click the placed cross and select Restore Fitting.
The placed fitting changes to a coupling fitting at the same position.
Replace Existing Fittings
You can replace one occurrence of a selected fitting instance with a new fitting
instance from the Content Center or all occurrences at once. The replacement
fittings can be inserted at previously defined route points.
Replaced fittings use the route information of the previous part. Orientation
and position can be adjusted if the part type and connection information
allows.
In this exercise, you place a tee from the Content Center to replace the
coupling you just restored from the placed cross. In addition, you can also
place a non-library replacement fitting using the Place Fitting tool.
Replace existing fittings with library fittings
1 Activate the AirSystem1:1 run.
134 | Chapter 6 Editing Rigid Routes and Runs