2009

Pipe Settings dialog box. These settings are only available when the check
box is cleared.
3 Activate the pipe run.
4 Right-click the pipe run or a specific route, and then select Display/Update
Settings, or click the pipe run or a specific route, and then select the
Display/Update Settings tool on the standard toolbar.
5 Select the display and update setting you need.
6 Use the default setting, All Tube & Pipe Objects, so that you can view
automatic responses to edits on routes and runs.
Route Points
A route is considered finished when you select Finish Edit. You can also use
the Route tool to repair disjointed routes.
A disjoint route can occur when segments are deleted from a route. While
deleting segments, you can use the Route tool to close the gap between disjoint
segments.
Add to Finished Routes
New route points can be added to a previously finished route by activating
the route to edit, and then using the Route tool on the end route point.
Add a point to an existing route
1 Activate Route03 in the AirSystem1:1 run.
2
In the graphics window or Model browser, do either of the
following:
■ Click the last route point, and select the Route tool on the Route panel
bar.
■ Right-click the last route point, and select the Route tool.
The route resumes at the last selected route point.
116 | Chapter 6 Editing Rigid Routes and Runs