2009
Table Of Contents
- Contents
- Tubes and Pipes
- 1 Getting Started with Tube & Pipe
- 2 Route Basics
- 3 Setting Styles
- 4 Creating Rigid Routes and Runs
- General Workflow for Rigid Routes
- Creating Auto Route Regions
- Manually Creating Parametric Regions
- Automatically Dimension Route Sketches
- Create Segments With Precise Values
- Define Parallel and Perpendicular Segments
- Snap Route Points to Existing Geometry
- Place Constraints On Route Sketches
- Create Bends Between Existing Pipe Segments
- Create Pipe Routes With Custom Bends
- Create Bent Tube Routes
- Realign 3D Orthogonal Route Tool
- Control Dimension Visibility
- Populated Routes
- 5 Creating and Editing Flexible Hose Routes
- 6 Editing Rigid Routes and Runs
- 7 Using Content Center Libraries
- 8 Authoring and Publishing
- 9 Documenting Routes and Runs
- Cable and Harness
- 10 Getting Started with Cable and Harness
- 11 Working With Harness Assemblies
- 12 Using the Cable and Harness Library
- 13 Working with Wires and Cables
- About Wires and Cables
- Setting Modeling and Curvature Behavior
- Inserting Wires and Cables Manually
- Moving Wires and Cables
- Deleting Wires and Cables
- Replacing Wires
- Assigning Virtual Parts
- Importing Harness Data
- Adding Shape to Wires and Cable Wires
- Setting Occurrence Properties
- Changing Wire and Cable Displays
- 14 Working with Segments
- 15 Routing Wires and Cables
- 16 Working with Splices
- 17 Working with Ribbon Cables
- 18 Generating Reports
- 19 Working Nailboards and Drawings
- IDF Translator
- Index
Start Fitting and End Fitting
Use the style to modify fittings in flexible hose routes. You can change existing
fittings, remove a fitting, or restore a suppressed fitting.
In this exercise, the hose style in use has specified the start fitting only and
suppressed the end fitting. You must do the following:
■ Change the start fitting.
■ Add a new end fitting.
■ Suppress the newly added end fitting.
NOTE If you want to remove both start fitting and end fitting, you can choose to
suppress the start fitting and the end fitting is suppressed automatically.
Replace the start fitting
1 In the AirSystem1:1 run, activate Hose02 in the Flexible Hose 02
subassembly.
2 On the Route panel bar, click the Tube & Pipe Styles tool.
3 Under Components, look at the Start Fitting used in the style.
4 Click Edit.
5 Right-click the Start Fitting row and select Browse to access the Content
Center. The Library Browser filters out all the hose family and fittings in
compatible standards.
6 Select Parker Male Taper Thread - Swivel from the list.
7 Click OK.
8 In the Tube & Pipe Styles dialog box, click Save, and then click Close.
9 Right-click and select Finish Edit.
The start fitting in the graphics window and in the Model browser is
changed.
Add and suppress an end fitting
1 Open the Tube & Pipe Styles dialog box and ensure the hose route style
to receive the new end fitting, Hydraulic Hose- Female Thread - Swivel
(1/2 ND 1) is the active style.
Start Fitting and End Fitting | 103