2009
Table Of Contents
- Contents
- Tubes and Pipes
- 1 Getting Started with Tube & Pipe
- 2 Route Basics
- 3 Setting Styles
- 4 Creating Rigid Routes and Runs
- General Workflow for Rigid Routes
- Creating Auto Route Regions
- Manually Creating Parametric Regions
- Automatically Dimension Route Sketches
- Create Segments With Precise Values
- Define Parallel and Perpendicular Segments
- Snap Route Points to Existing Geometry
- Place Constraints On Route Sketches
- Create Bends Between Existing Pipe Segments
- Create Pipe Routes With Custom Bends
- Create Bent Tube Routes
- Realign 3D Orthogonal Route Tool
- Control Dimension Visibility
- Populated Routes
- 5 Creating and Editing Flexible Hose Routes
- 6 Editing Rigid Routes and Runs
- 7 Using Content Center Libraries
- 8 Authoring and Publishing
- 9 Documenting Routes and Runs
- Cable and Harness
- 10 Getting Started with Cable and Harness
- 11 Working With Harness Assemblies
- 12 Using the Cable and Harness Library
- 13 Working with Wires and Cables
- About Wires and Cables
- Setting Modeling and Curvature Behavior
- Inserting Wires and Cables Manually
- Moving Wires and Cables
- Deleting Wires and Cables
- Replacing Wires
- Assigning Virtual Parts
- Importing Harness Data
- Adding Shape to Wires and Cable Wires
- Setting Occurrence Properties
- Changing Wire and Cable Displays
- 14 Working with Segments
- 15 Routing Wires and Cables
- 16 Working with Splices
- 17 Working with Ribbon Cables
- 18 Generating Reports
- 19 Working Nailboards and Drawings
- IDF Translator
- Index
■ A connection on a standard Autodesk
®
Inventor
™
part that has been
authored using the Tube & Pipe Authoring tool and published to the
Content Center
■ The end of a tube, pipe, or hose segment
■ A circular edge on any component
Create Hose Routes with Both Fittings
In this exercise you create a new run, and then use a flexible hose style you
created earlier to create a hose route. The style specifies a subassembly structure
that contains both a start and end fitting.
Create a hose route subassembly with both start and end fittings
1 Activate the master runs assembly, click the Create Pipe Run tool on the
Tube & Pipe Runs panel bar. Enter AirSystem2 for the run file name and
accept the default file location.
The new run is activated.
2 On the standard toolbar, select the Hydraulic Hose- Female Thread -
Swivel (1/2 ND 2) style from the Active Style list.
3 On the Tube & Pipe panel bar, click the New Route tool.
The Create Hose dialog box appears with the default file name and file
location.
4 Accept the default hose assembly file name and location.
The Flexible Hose 01 subassembly is added under the AirSystem2:1run.
The Hose1 route is activated by default.
5 Click the Route tool.
The start fitting specified by the hose style is attached to the cursor and
ready for placement.
Create Hose Routes with Both Fittings | 91