Setup guide

9
(CAL1, CAL2, CAL3). You may want to setup CAL1 to (native) wide-gamut mode and CAL2 to
emulate a video monitor (or vice versa).
Autodesk does not recommend using either the sRGB or the rec709 presets that are built into
the monitor. Please note that the rec709 mode is quite different from a traditional HD video
monitor. However, if you ignore this advice, please at least leave the "Range Extension" option
in the monitor's on-screen menus at "Off" (which is its default setting).
Configuring the EIZO CG245W Monitor
To accommodate all the refresh rates used by the Creative Finishing software, you need to modify the
Range of Frequency settings on the EIZO CG245W monitor.
Note: The monitor does not need to be connected to a computer to perform this procedure.
1. Ensure the power cable is connected to the monitor.
2. Ensure the power switch on the back of the monitor is on.
3. Ensure the monitor is turned off. If it is not, press to do so.
4. Press and hold down the and buttons for at least 2 seconds.
This will enable a hidden menu called Optional Settings.
5. Use the and buttons to select the Signal Bandwidth menu item, and press .
6. Select DVI-1 and press .
7. Select Wide-3 and press .
8. Select DVI-2 and press .
9. Select Wide-3 and press .
10. Select DisplayPort and press .
11. Select Wide and press .
At this point, the settings should be as follows:
12. Press to go back.
13. Use the and buttons to select Finish.
14. Press to save the configuration.
Note: Do not skip this step; otherwise the changes will not be saved.