Setup guide

4
Make sure to also connect the supplied DVI extender power adapter to the DVI extender cable,
otherwise the monitor will not display an image.
3. Connect the keyboard, mouse and graphics tablet directly to the USB ports of the workstation,
or to an USB extender.
4. Connect the bottom on-board Ethernet port of the workstation (port 0) to your facility network.
5. If configuring a Lustre workstation, connect the Ethernet cable coming from the Autodesk
Control Surface Ethernet switch to the top on-board Ethernet port of the workstation.
6. If configuring a Lustre workstation, connect the USB cable coming from the central panel of the
Autodesk Control Surface to an USB port on the workstation or to the USB extender.
7. Optional: Connect one port of the InfiniBand adapter to the InfiniBand switch.
Connecting Video Components
The following diagram illustrates how to connect the video hardware components included in your
shipment.
The only video hardware you must provide are a sync generator, VTR, HD/SDI-ready broadcast monitor
and patch panel (if desired).