Technical data

Chapter 2 Getting Started with AutoCAD Land Development Desktop
88
The Object Snap tab also controls the use of object snap tracking.
With object snap tracking the cursor can track along alignment paths
based on other object snap points when specifying points in a
command. For more information, see “Object Snap Tab” in the online
Help, and “AutoTrack” in this chapter.
You can use the Object Snap shortcut menu, shown in the following
illustration, to specify a specific object snap to use for a point, even
when running Osnaps are not turned on.
To display the object snap shortcut menu, run a drawing command
like LINE, then press the SHIFT key and right-click.
For more information, use to look up “Snapping to Points on
Objects” in the online Help.