Technical data

Chapter 7 Listing and Annotating Plans
230
■
List which breaklines are defined in the project by using the List
Breaklines command from the Breaklines shortcut menu in the
Terrain Model Explorer.
■
Show statistics for a surface model in the Terrain Model Explorer.
■
Create alignment, stakeout, volume, and parcel reports.
To track the elevation of a surface
Steps
Use
to look up
1
Build a surface.
Build a Surface
2
Make that surface the current surface.
Make a Surface Current
3
From the Inquiry menu choose Track Elevation.
Track Elevations
4
Move the pointing device over the surface.
The surface elevation is displayed on the status
bar. If you move the pointing device outside the
surface area, then an out of bounds message is
displayed.
To list the station and offset of a location in relation to the current alignment
Steps
Use
to look up
1
Define an alignment.
Overview of Defining
Alignments
2
From the Inquiry menu, choose Station/Offset
Alignment.
List the Station and Offset
of a Location in Relation to
the Current Alignment
3
Select a location on screen that is adjacent to the
current alignment.
The station and offset of the location is listed on
the command line.