2011

Table Of Contents
8 The image of the arrow is then dragged into Schematic and linked to the
composition and attached to the Front input of the Blend and Comp
node.
9 A 2D Transform tool is then added between the arrow image and the
Blend and Comp node. Select the 2D Transform node.
10 From the 2D Transform tool UI, select 1 Point from the Transform Type
menu. The Source and Destination coordinate value editors appear.
11 The Source X and Y coordinates are set to 0, 0 fixing the center of the
arrow image exactly at the center of the tracker.
12 To set the Destination transform, right click on the Destination label and
select Set Tracker. The Tracker Selector appears. Expand the Tracker and
select the Tracker Analyzer.
13 Enable Use Offset and click the Link button.
772 | Chapter 32 Tracking and Stabilizing