2011

To change the edge distance or position:
1 Do one of the following:
■ Drag the outer edge handle towards the outside of the mask to create
an outer edge gradient, or towards the center of the mask to create
an inner edge gradient.
■ Type the distance (in pixels) into the Distance value editor and
position (relative to the first control point generated for the mask)
then press Enter.
■ Click + drag inside the value editor.
NOTE You can also multi-select several edge handles using the Shift key and
change the distance or position of more than one edge by the same value.
2 Press Alt to lock the position of the edge while changing its distance.
To change the color of an edge handle:
1 Select any shape.
2 Click the color pot under Edge Settings.
3 Select a new color from the Color Picker UI and click Set.
NOTE This operation changes the color of every edge handle in the mask.
To set the edge handle visibility to not visible:
➤ Click the Visible (default) button under Edge Settings.
User Settings
Each tab has a set of User Setting buttons you can use to store initial mask
parameters that can be reused during the rotoscoping process. By default, the
first time you create a mask without changing any initial settings, the mask
will have the following default settings.
User Settings | 555