2.0

Using the Finished Draft Pipe Run Layer Tools
697
Turning On the Profile Layers
To turn on a selected profile layer
1 From the Pipes menu, choose Conceptual Layers ä Profile On.
2 Select the pipe run.
3 Press ENTER to open the Defined Runs dialog box and select the run, then click
OK.
Turning Off the Profile Layers
To turn off a selected profile layer
1 From the Pipes menu, choose Conceptual Layers ä Profile Off.
2 Do one of the following to select the pipe run:
n
Select the run with your pointing device.
n
Press ENTER to open the Defined Runs dialog box and select the run, then
click OK.
Using the Finished Draft Pipe Run Layer Tools
With the finished draft pipe run layer tools, you can manipulate layers for
finish draft pipe runs. These are more complex representations of pipe runs in
plan and profile views.
Deleting the Finished Draft Plan Layers
To delete the finish plan layers
1 From the Pipes menu, choose Finish Draft Plan ä Delete Layer.
2 Do one of the following:
n
Select the pipe run by graphically selecting the run with your pointing device
n
Press ENTER and select the run from the Define Runs dialog box, then click
OK.
The following prompt is displayed
Delete Selected Pipe Run <{name}> Layers (Yes/No/Cancel)? <Yes>:
3 Enter Yes to delete the layers for the selected pipe run.
The following prompt is displayed:
Erasing entities on layer <{name}> ...
Erasing entities on layer <{name}> ...
done!
NOTE
Because all entities on the pipe run layer are deleted by the Delete Layer
command, you should place each pipe run on a unique layer when
establishing the pipe run layer settings.