2.0

Editing Conceptual Plan Pipe Runs Using the Pipe Run Editor
675
Editing Conceptual Pipe Runs in Plan View -
Column Headings
Pipe Runs in Plan View
Column Headings Description
% d/D
This column contains the percentage full value for the pipe at the design flow rate. The d
represents the depth of flow, the D the pipe diameter. This value is determined by the
current pipe configuration and flow calculation formula. You can make your own
percentage full at the design flow rate calculations if necessary. Place your cursor in the %
d/D column and click Edit to open the appropriate Pipe Calculator dialog box.
Adjusted Length
This column contains the adjusted length value of the pipe segment.
Cen-Cen 2Dlength
This column contains the center-to-center 2D pipe length value, which is calculated based
on the Northing and Easting values of the pipe segments starting and ending points.
Cen-Cen 3Dlength This column contains the center-to-center 3D length value of the pipe segment.
Critical Depth
This column contains the critical depth value for the pipe segment.
Critical Slope
This column contains the critical slope value for the pipe segment.
Critical Velocity
This column contains the critical velocity value for the pipe segment.
D. Point Flow
This column contains the design point flow value, which is calculated for the current pipe
segment based on the percent full value setting made in the Pipes - Editor Settings dialog
box. You can make your own design point flow value calculations if necessary. Place your
cursor in the D. Point column and click Edit to open the appropriate Pipe Calculator dialog
box.
Design Depth
This column displays the depth of flow value, d, for the design flow. This value is
determined based on the current pipe configuration and flow calculation formula. You can
make your own depth of flow calculations if necessary. Place your cursor in the Design
Depth column and click Edit to open the appropriate Pipe Calculator dialog box.
Design Flow
This column contains the design flow value, which the Pipes Run Editor automatically
calculates by adding the pipe flow, lateral flows #1 and #2, infiltration inflow, and
upstream flow values.
Design Vel.
This column contains the design velocity flow value for the pipe segment. This value is
determined based on the current pipe configuration and flow calculation formula. You can
make your own design velocity flow calculations if necessary. Place your cursor in the
Design Vel. column and click Edit to open the appropriate Pipe Calculator dialog box.
East This column contains the easting value of the nodes location point in the pipe run.
EGL Elev In
This column contains the energy grade line elevation in value for the pipe segment.
EGL Out
This column contains the energy grade line elevation out value for the pipe segment.