2.0

Chapter 6 Working with Pipes
646
3 Select the Station check box to place station labels for the finished profile
structure, based on the current alignment, in the finished draft, and then do the
following:
n
In the Prefix box, type the prefix for the profile structure label.
n
In the Suffix box, type the suffix for the profile structure label.
n
Use the Precision slide box to set the precision value for the profile structure.
NOTE
When entering a prefix or suffix, you can include a space to separate the
prefix and suffix from the value.
4 In the Offsets section, do the following tasks to control the placement of left
and right perpendicular offset labels for the current alignment:
n
Select Right to place right perpendicular offset labels for the current
alignment in the finished draft.
n
In the Prefix box, type the prefix for the right perpendicular offset label for
the current alignment.
n
In the Suffix box, type the suffix for the right perpendicular offset label for
the current alignment.
n
Use the Precision slide box to set the precision value for both the right and
left offset label.
n
Select Left to place left perpendicular offset labels for the current alignment
in the finished draft.
n
In the Prefix box, type the prefix for the left perpendicular offset label of the
current alignment.
n
In the Suffix box, type the suffix for the left perpendicular offset label of the
current alignment.
n
Use the Precision slide box to set the precision value for both the right and
left offset.
5 In the Elevations section, do the following tasks to control the placement of the
pipe, sump, and rim elevation labels:
n
Select Pipe to place the invert (in and out) pipe structure elevation labels in
the finished draft.
n
In the Prefix box, type the prefix for the profile pipe structure elevation label.
n
In the Suffix box, type the suffix for the profile pipe structure elevation label.
n
Use the Precision slide box to set the precision value for the profile pipe
structure elevation label.
n
In the Elev. In box, type the label for the invert in labels.
n
In the Elev. Out box, type the label for the invert out labels.
These settings are used in conjunction with the station value, which is
recalculated each time a run is labeled.
6 Select the Sump check box to place sump elevation labels in the finished draft,
and then do the following:
n
In the Prefix box, type the prefix for the sump elevation label.
n
In the Suffix box, type the suffix for the sump elevation label.
n
Use the Precision slide box to set the precision value for the sump elevation
label.