2.0

Chapter 6 Working with Pipes
644
3 To place station labels for the finished plan structure in the finished draft based
on the current alignment, select the Station check box and do the following:
n
In the Prefix box, type the prefix for the plan structure label.
n
In the Suffix box, type the suffix for the plan structure label.
n
Use the Precision slide box to set the precision value for the plan structure
label.
NOTE
When entering a prefix or suffix, you can include a space to separate the
prefix and suffix from the value.
4 In the Offsets section, select the Right or Left check box to place right or left
perpendicular offset labels in the finished draft, and then do the following:
n
In the Prefix box, type the prefix for the right or left perpendicular offset
label for the current alignment.
n
In the Suffix box, type the suffix for the right or left perpendicular offset
label for the current alignment.
n
Use the Precision slide box to set the precision value for both the right and
left offset label.
Use the options to control the placement of the pipe, sump, and rim elevation
labels.
NOTE
These settings are used in conjunction with the station value, which is
recalculated each time a run is labeled.
5 In the Elevations section, select the Pipe check box to place invert (in and out)
pipe structure elevation labels in the finished draft, and then do the following:
n
In the Prefix box, type the prefix for the profile pipe structure elevation label.
n
In the Suffix box, type the suffix for the profile pipe structure elevation label.
n
Use the Precision slide box to set the precision value for the profile pipe
structure elevation label.
n
In the Elev. In box, type the text for the invert in labels.
n
In the Elev. Out box, type the text for the invert out labels.
6 To place sump elevation labels in the finished draft, select the Sump check box,
and then do the following:
n
In the Prefix box, type the prefix for the sump elevation label.
n
In the Suffix box, type the suffix for the sump elevation label.
n
Use the Precision slide box to set the precision value for the sump elevation
label.
7 To place rim elevation labels in the finished draft, select the Rim check box, and
then do the following:
n
In the Prefix box, type the prefix for the rim elevation label.
n
In the Suffix box, type the suffix for the rim elevation label.
n
Use the Precision slide box to set the precision value for the rim elevation
label.
Use the options to control the placement of the prefix and suffix for the node
name label.