2.0

Table Of Contents

Configuring the Grading Accuracy Settings

The following illustration shows automatic spacing with increment.

Automatic spacing with increment

NOTE

Automatic Spacing will not be applied in the following situations:

on an arc with different endpoint elevations

in a slope transition on an arc

In both of these situations, the projection increment defaults to the value

you enter in the Increment Along Arc Segments box.

Enter the following increment values:

In the Increment Along Straight-Line Segments box, enter the value in

drawing units for the increment you want to use for straight-line segments,

and miter and chamfer corners.

In the Increment Along Arc Segments box, enter the value in drawing units

for the increment you want to use for curved segments and radial projections

on radial corner treatments.

NOTE

The increment distance for convex arcs and radial corners is the

distance along the daylight line between slope projection lines. The

increment distance for concave arcs is the distance between projection

lines along the footprint.

You can configure other grading settings or exit the command.

If you want to  Then

configure other grading settings use the Next or Back button to continue to

another sheet in the Grading Wizard.

In the grading properties, you can select another

tab at the top of the dialog box to continue.

exit the command click finish to close the Grading Wizard or click

OK to close the grading properties dialog box.