2.0

Editing Individual Corner Treatments
37
Mitered Convex Corners when Grading Horizontally
For mitered convex corners grading horizontally, the corner will be horizontal,
even when the footprint elevations are not the same. When a miter corner
grades horizontally in a situation where the segments in and out of the corner
are not at the same grade, a flat corner is produced.
Concave Interior Miter Cleanup
Concave interior miter cleanup between a line and a non tangent arc, or two
non tangent arcs, may not always clean up as expected. In some situations a
small jump may occur at the end of the miter line. To accommodate this
situation you can adjust the footprint design or explode the object, and then
manually clean up the area.
Interior Corner Cleanup Where Slope Tags and Target Regions
Are Located
If a slope tag or a target region is placed within a concave miter interior corner,
the corner will not cleanup properly. To correct this you must move the slope
tag or target region out of the corner cleanup area.
Editing Individual Corner Treatments
You can use the Edit Corners dialog box to change the corner treatment for the
grading object on a corner-by-corner basis. When you click in the Corner
Treatment column in the spreadsheet section of the corner settings, the Edit
Corners dialog box is displayed.
NOTE
The miter corner cleanup method is automatically applied to any concave
corners on the footprint. This is not editable.
NOTE
Corner cleanup is not applied when a slope tag or target region boundary
lies within the corner cleanup. You must move the target region or slope
tag out of the corner cleanup area.
To edit individual corner treatments
1
Click in the Corner Treatment column in the Corners tab to display the Edit
Corner dialog box.