2.0

Outputting the Section Data for Use in Other Software Programs
461
The following prompt is displayed:
Enter filename to output:
3 Specify the file name.
When entering the file name, be sure to include the extension. If the file
already exists, a prompt is displayed asking whether or not to overwrite the file.
4 On the command line, type Y or N:
n
Type Y for Yes to overwrite the existing file.
n
Type N for No to show the command prompt for the folder and file name
again.
The following prompt is displayed:
Volume computation type (Prismoidal/Avgendarea) <Avgendarea>:
5 Specify the volume computation type, Prismoidal or Avgendarea:
n
Average End Area Calculation: For the average end method, the
calculations for volumes takes the area of cut or fill at one station plus the
area of the cut or fill at the next station divided by two, multiplied by the
distance between the stations. The commands calculate all data from the
actual values, but the reported values are rounded to the volume precision of
your choice.
n
Prismoidal Calculation: The prismoidal method of calculating volumes is
more accurate than the average end area method. However, this technique
involves a more complicated calculation and may take a longer time to
process.
The prismoidal method calculation is:
Total sum of cut (or fill) area at first station (A1), cut (or fill) area at second
station (A2) plus the square root value of A1*A2. Divide the total sum by 3
and multiply by the distance between the two sections.
The following prompt is displayed:
Use curve correction (Yes/No) <Yes>:
6 Specify whether to use curve correction:
n
Type Y to use curve correction.
n
Type N to skip this option.
In normal volume calculations, the length between the end areas on horizontal
curves is taken from the length along the centerline curve. With curve
correction in use, the length is taken from the path of the average centroid of
the areas for a more accurate result.
A prompt is displayed asking if you want to use volume adjustment factors.
7 Specify whether you want to use volume adjustment factors:
n
Type Y to use volume adjustment factors. You are then prompted for the cut
and fill adjustment factors.
n
Type N to skip this option.