2.0

Plotting and Outputting the Cross Sections
417
3 Decide whether to import the page(s) into the current drawing by doing one of
the following:
If you
}
Then type
}
want to import pages into
the current drawing
Y
for Yes and enter a starting station.
Enter a starting station and a sheet origin point. The starting
station for the first plotted section and the lower left corner of
the sheet are prompted for regardless of where the cross
sections are being imported.
do not want to import
pages into the current
drawing
N
for No and enter the drawing prefix.
Enter the drawing prefix, the starting sheet number, a starting
station and a sheet origin point. The drawing prefix can have a
maximum of 5 characters. The name of the drawing is based
on the drawing prefix entered and the sheet number. For
example, if the drawing prefix is 202cl and the first sheet
number is 1, the drawing containing the first page of cross
sections is named 202cl001. These drawings are created in the
Land Development Desktops install folder.
NOTE
If there are any drawing entities within the sheet boundary, then they are
also written out.
The following illustration shows a single page of cross sections:
One page of cross sections