2.0

Chapter 4 Working with Cross Sections
376
NOTE
The values in this dialog box are for display only, you cannot edit them.
2 Click the Next, Previous, and Station buttons to move between stations.
When you click Station, the Station Entry dialog box is displayed. Type the
value for the station you want to see, and then click OK.
3 Click Benches to view the left and right bench information.
In the Benches dialog box, click the Next, Previous, and Station buttons to
move between stations. When you click Station, the Station Entry dialog box is
displayed. Type the value for the station you want to see then click OK. Click
OK in the Benches dialog box after finishing the review of bench values.
4 Click Transitions to view information about the left and right transitions.
The first through fourth transitions are displayed in the initial Transitions
dialog box. Click More to display the fifth through eighth transitions. Click the
Next, Previous, and Station buttons to move between stations. When you click
Station, the Station Entry dialog box is displayed. Type the value for the station
you want to see, and then click OK. Click OK in the Transition dialog box to
return to the Design Control Parameters dialog box.
5 Click OK to exit the command.
Displaying the Actual Control Values for Any
Section
To display the actual control values for any section
1 From the Cross Sections menu, choose Design Control ä Display Actual
Control to display the Actual Control Parameters dialog box.
This dialog box shows you the actual control parameters that were applied at
each station, including catch point offsets and elevations. The top portion of
the dialog box displays the alignment name, current station, template name,
and centerline elevation. The cut and fill areas are also displayed.