2.0

Creating the Roadway Superelevation with Templates and Cross Sections
367
2 Enter the starting and ending stations of the range to be edited, and then click
OK.
The range can be any subset of the entire alignment. Use a subset of the
alignment to apply different templates to different ranges of stations or to do
specialty transitions. The defaults are the starting and ending stations of the
current alignment. The stations that determine the desired range must be
entered as decimal values.
If you enter a station that was not sampled with the Sample From Surface
command or Sample From File command, the command defaults to the next
existing station.
NOTE
Do not enter a plus sign (+) in the station value. For example, enter
1000
for station 10+00 or 1+000.
After entering the starting and ending stations, the Process Status dialog box is
displayed. This is strictly an informational dialog box that displays information
about the current alignment, station range, and processing station.
3 Review the information, and then click OK to continue. If errors occur during
the section processing, the Section Processing Status dialog box is displayed.
4 If the Section Processing Status dialog box displays, you can do the following:
n
Click the View Errors button to display the error(s) that occurred during the
section processing, or click OK to continue.
n
Print the errors to a file by clicking the Print to File button on the Control
Processing Errors dialog box.
Resetting the Cross Section Processing Settings
Back to the Default Project Settings
To reset the cross section processing settings back to the default project
settings
1 From the Cross Sections menu, choose Design Control
ä
Reset Section Control
to display a Warning dialog box.
2 Click Yes or No:
n
Click Yes to reset the control values with default project settings. All Design
Control information that has been applied to the templates is overwritten by
the values set for Design Control with the Project Settings. All stations in the
alignment now use the default values for applying the template to cross
sections.
n
Click No to end the command without resetting the values.
NOTE
You must reprocess the cross sections with the Process Sections command
before the new values take effect.