2.0

Defining Pond Slopes
111
4 Reset the pattern data:
If you want to} Then type}
remove the pattern data for all pond
vertices
All
.
select multiple vertices to reset Multiple
, and then use the Next or
Previous options to select the vertices;
type End to finish.
remove the pattern data from the
current vertex
Individual
.
5 Type eXit to exit the command.
Drawing a Pond Slope Template
One method of creating the slope data for a pond is to use a template. A
template is a cross-section of the pond bank and is used to define the exact
shape and configuration for either all or part of the pond.
Use the Draw Template command to draw a template for the pond as a 2D
polyline. The template can be either a single segment or multiple segments with
different slopes.
To draw a template, you must:
n
Draw the template in an upper-left to lower-right direction.
n
Draw the template at a 1:1 scale.
n
Draw all segments of the template so that they have a negative slope, or are
horizontal or vertical.
n
Draw only straight-line segments. A template cannot contain arc segments.
NOTE
Pond templates do not use the vertical scale factor like roadway templates
do.
When you use the Draw Template command, the template is drawn on the
current layer.
To draw a pond slope template
1 From the Grading menu, choose Pond Slopes
ä
Draw Template.
The following prompt is displayed:
From point:
2 Select the starting point.
The following prompts are displayed:
Current line-width is 0.00
Arc/Close/Halfwidth/Length/Undo/Width/<Endpoint of line>: