2.0

Chapter 2 Working with Ponds
94
2 Type a distance or select two points in the drawing to define the distance.
The following prompt is displayed:
First elevation <0.0000 m>:
3 Type the elevation of the first vertex on the perimeter you selected.
The following prompt is displayed:
Second elevation <0.0000 m>:
4 Type the elevation of the last vertex on the perimeter. A new polyline is then
drawn, and the elevation of the polyline is interpolated between the two
elevations you specified.
5 Select another pond perimeter that you want to add vertices to, or press ENTER
to end the command.
Adding Vertices By Entity Option
To add vertices using the Entity option
1 Select the polyline.
The following prompt is displayed:
Distance to set additional tangent vertices <3.0000 m>:
2 Type a distance or select two points in the drawing to define the distance.
The following prompt is displayed:
Additional curve vertices by (Number/Mid-ordinate/Distance) <Distance>:
3 Do one of the following to define how additional vertices are created on curves:
n
Type Distance, and then type a distance or select two points in the drawing
to define the distance.
n
Type Number, and then type the number of vertices you want to add to the
curve segments.
n
Type Mid-ordinate to add vertices based on the mid-ordinate distance of the
curve.
NOTE
This prompt is displayed whether or not there are curves in the pond
perimeter.
The following prompt is displayed:
Erase old entity? <Yes>:
4 Type Yes or press ENTER to erase the old entity, or type No to keep the old
entity.
5 Select another pond perimeter that you want to add vertices to, or press ENTER
to end the command.
NOTE
The first time you run this command on a selected perimeter, all of the
prompts described in this topic are displayed. However, the second time
you run this command, you are only prompted for a distance to add
additional vertices. You are not prompted to define how additional curve
vertices are created.