2012

To update existing block references with attributes you have modified
1 Click Home tab ➤ Block panel ➤ Manage Attributes.
2 In the Block Attribute Manager, select a block from the Block list, or click
Select Block and select a block in the drawing area.
3 Click Sync to update attributes you have changed in all block references
for the selected block.
To update the attributes in block references for a selected block definition
1 Click Home tab ➤ Block panel ➤ Synchronize Attributes.
2 At the prompt, do one of the following:
■ Enter name, and then enter the name of the block whose block
references you want to update.
■ Enter ? to view a list of blocks, and then enter name, followed by the
name of the block.
■ Press Enter, and then use your pointing device to select a block in the
drawing area.
If you specify a block that does not exist, or if the block exists but does
not contain attributes, an error message is displayed.
Alternate
1 Click Home tab ➤ Block panel ➤ Edit Single Attribute.
2 In the drawing area, select the block you want to edit.
3 In the Enhanced Attribute Editor, select the attribute you want to edit.
You can change the attribute value or choose another tab and edit other
attribute properties.
4 Make the attribute changes you want, and then do one of the following:
■ Click Apply to save your changes. The Enhanced Attribute Editor
remains open.
If you click Cancel later to exit the Enhanced Attribute Editor, attribute
changes you made prior to choosing Apply are not reversed.
Modify a Block Attribute Definition | 961