2012

Table Of Contents
To create a circle tangent at three points, set running object snaps (OSNAP)
to Tangent and use the three-point method to create the circle.
See also:
Use Object Snaps on page 626
Draw Isometric Circles on page 2141
To draw a circle by specifying a center point and radius or diameter
1 Do one of the following:
Click Home tab Draw panel Circle drop-down Center,
Radius.
Click Home tab Draw panel Circle drop-down Center,
Diameter.
2 Specify the center point.
3 Specify the radius or diameter.
To create a circle tangent to two objects
1 Click Home tab Draw panel Circle drop-down Tan, Tan, Radius.
The command starts Tangent object snap mode.
2 Select the first object to draw the circle tangent to.
Draw Circles | 713