2012

Use polyline objects instead of line objects if you want the segments to be
connected as a single object.
See also:
■ Enter Coordinates to Specify Points on page 606
■ Use Object Snaps on page 626
■ Adjust Grid and Grid Snap on page 635
■ Draw Polylines on page 693
■ Offset an Object on page 815
■ Break and Join Objects on page 843
■ Infer Geometric Constraints on page 885
To draw lines
1 Click Home tab ➤ Draw panel ➤ Line.
2 Specify the start point.
You can use the pointing device or enter coordinate values at the
Command prompt.
3 Complete the first line segment by specifying the endpoint.
To undo the previous line segment during the LINE command, enter u
or click Undo on the toolbar.
4 Specify the endpoints of any additional line segments.
5 Press Enter to end or c to close a series of line segments.
To start a new line at the endpoint of the last line drawn, start the LINE
command again and press Enter at the Specify Start Point prompt.
Quick Reference
Commands
LINE
Creates straight line segments.
692 | Chapter 18 Create Objects