2012

Table Of Contents
NOTE Alternatively, you can enter lightingunits at the command prompt
and set the value to 0 for standard (generic) lighting.
2 Click Render tab Sun & Location panel
Sun Properties.
3 In the General settings, click the Status setting, and select On or Off.
To change the brightness of the sun
1 Click Render tab Lights panel Lighting Units drop-down
Generic Lighing Units.
No lighting units are used and standard (generic) lighting is enabled.
NOTE Alternatively, you can enter lightingunits at the command prompt
and set the value to 0 for standard (generic) lighting.
2 Click Render tab Sun & Location panel
Sun Properties.
3 In the General settings, click the Intensity Factor setting, and select a
new value.
To change the geographic location of your model
1 Click Render tab Sun & Location panel Set Location.
2 In the Location Already Exists task dialog box, click Edit Current
Geographic Location.
3 In the Geographic Location dialog box, enter the appropriate values.
4 Click OK.
To change the angle of the sun
1 Click Render tab Sun & Location panel
Sun Properties.
2 In the Sun Angle Calculator settings, click the Date setting, and select a
new date.
2196 | Chapter 44 Add Lighting to Your Model