2012

Table Of Contents
Format codes for paragraphs
To produce this Enter this PurposeFormat code
\A1;1\S1/2Sets the alignment value;
valid values: 0, 1, 2
(bottom, center, top)
\A
Autodesk\PAutoCADEnds paragraph\P
Braces can be nested up to eight levels deep.
You can also use control codes to add special characters, such as tolerance or
dimensioning symbols. See MTEXT.
Example: Formatting Text in an Alternate Text Editor
This example describes how the text in the following illustration was created.
Each line below was entered in an alternate text editor:
{{\H1.5x; Big text} \A2; over text\A1;/\A0; under text}\P
{\A0;Baseline: 1 \S1/2;}\P
{\A1;Center: 1 \S1/2;}\P
{\A2;Topline: 1 \S1/2;}\P
{Tolerances: \A1;1.000\H.75x;\S+0.010^-0.000;}\P
{Architectural: 9-{\H.666x;\A2;11\A1;/\A0;16}\A2;"}\P
1500 | Chapter 29 Notes and Labels