2012

Table Of Contents
To set the scale of a hatch pattern (ribbon turned on)
1 Click Home tab Draw panel Hatch.
2 On the Properties panel, click Pattern from the Hatch Type drop-down
list.
3 On the Pattern panel, click a hatch pattern.
4 On the Properties panel, enter a hatch pattern scale.
5 Specify a point inside each area that you want to hatch.
6 Press Enter, or click Close on the ribbon to apply the hatch and exit the
command.
To set the scale of a hatch pattern (ribbon turned off)
1 Start the Hatch command from a menu or toolbar.
2 In the Hatch and Gradient dialog box, Hatch tab, under Type and Pattern,
click Predefined from the Type drop-down list.
3 Select a pattern from the Pattern drop-down list.
4 Under Angle and Scale, enter a new scale value or click the drop-down
arrow to display a list of scales.
5 Under Boundaries, click Add: Pick Points.
6 Specify a point inside each area that you want to hatch and press Enter.
7 Click OK to apply the hatch.
Quick Reference
Commands
HATCH
Fills an enclosed area or selected objects with a hatch pattern, solid fill, or
gradient fill.
HATCHEDIT
Modifies an existing hatch or fill.
1382 | Chapter 28 Hatches, Fills, and Wipeouts