2012

You can also choose the “fixed” option, which forces unchanged model
geometry to remain in the location it was prior to the update operation. Often,
this is preferred as less shift occurs.
If you update a view after you have added dimensions to the view geometry,
dimensions are likely to become disassociated. You are then prompted to step
through the affected dimensions and attach the extension-line origin points
of each disassociated dimension to the corresponding geometry. If necessary,
you can skip reassociating dimensions at this time and use the
DIMREASSOCIATE command later.
To update an out-of-date view
1 Click Annotate tab ➤ Drawing Views panel ➤ Update View drop-down ➤
Update View.
2 Click the view you want to update.
3 Press ENTER.
To specify how to anchor a view
1 Double-click the view you want to anchor.
2 On the Drawing View Editor contextual ribbon tab, click View Options.
3 From the View Justification list, select the desired anchor option.
■ To anchor the view so that it grows or shrinks around its center, select
Centered.
■ To anchor the view such that unchanged model geometry does not
move, select Fixed.
4 On the Drawing View Editor contextual ribbon tab, click OK.
Create Drawings from AutoCAD and Inventor 3D Models | 1285