2012

See also:
■ Modify Mesh Objects on page 1238
To set the maximum smoothness level for mesh objects
1 At the Command prompt, enter smoothmeshmaxlev.
2 Enter a value from 1 to 255.
(Use lower numbers to prevent extremely dense meshes that might affect
program performance.)
To set the maximum number of faces for mesh objects
1 At the Command prompt, enter smoothmeshmaxface.
2 Enter a value from 1 to 16,000,000.
To control the display of the mesh facet grid
1 At the Command prompt, enter smoothmeshgrid.
2 Set the smoothness level at which the mesh object displays the underlying
facet grid:
■ 0 hides the display of the underlying facet grid.
■ 1 displays the facet grid for smoothness levels 0 and 1.
■ 2 or higher specifies the highest level of smoothness at which the
facet grid is displayed.
To change the default level of smoothness of new mesh primitive objects
1 At the Command prompt, enter mesh. Then enter se (SEttings).
2 Enter a smoothness value and press Enter.
(A smoothness level of 5 or less is recommended.)
3 Press Esc to end the command or specify a mesh primitive type to create.
The smoothness value is retained for the current drawing session.
1114 | Chapter 24 Create 3D Models