2012

Table Of Contents
Wedge Creation Options
Use the following options to control the size and rotation of the wedges you
create:
Create a wedge with sides of equal length. Use the Cube option of the
WEDGE command.
Specify rotation. Use the Cube or Length option if you want to set the
rotation of the wedge in the XY plane.
Start from the center point. Use the Center Point option to create a wedge
using a specified center point.
To create a solid wedge based on two points and a height
1 Click Home tab Modeling panel Wedge.
2 Specify the first corner of the base.
3 Specify the opposite corner of the base.
4 Specify the height of the wedge.
To create a solid wedge with equal length, width, and height
1 Click Home tab Modeling panel Wedge.
2 Specify the first corner or enter c (Center) to set the center point of the
base.
3 At the Command prompt, enter c (Cube). Specify the length of the wedge
and a rotation angle.
The length value sets both the width and height of the wedge.
Create 3D Solid Primitives | 1055